Post Free Ad

EZ50 Stringing Gun - Cable feeding tool

EZ50 Stringing Gun - Cable feeding tool

The Stringing Gun EZ50 by Zeitler is used to feed a special pull line promptly and efficiently into conduits of Ø 18 to 50 mm (internal diameter) for electrical installation in private construction. Easy to apply even in buckled conduits, junction boxes, sockets and plugs. The simple way to blow or suck pull line. Facts • Blow or suck pull line without compressor • For all commercial pipe work (internal diameter from 18 to 50 mm) • Appropriate for flexible conduits • Installations in the range of private, office and industrial buildings • Huge time saving in cable feeding • Feeding of several hundred meters • Lightweight and compact • Excellent accessibility, even in confined spaces • Easy to handle • Double function (blowing and suction mode) • Perfect and strong to solve pull line feeding problems • Suitable in any car boot • Perfect value for money Zeitler AG Stringing Guns and Cable feeding Tools Sonnhalde 7 CH-6206 Neuenkirch/Switzerland Tel. +41 (0)41 467 16 14 Fax +41 (0)41 467 20 35 show contact info www.zeitler.ch Stringing Gun EZ50 for all electrical installations Intended Use: • insert a special pull line in all commercial conduits (int. ø 18 to 50 mm) • installations in the range of private houses, office and industrial buildings • for all commercial boxes, junction boxes, sockets, lamp boxes etc. (even in very confined spaces) • problems with f.e. kinked conduits can be solved by switching to suction mode, sucking the pull line from opposite end Function: • apply line brake • fit joint/nozzle appropriate to internal conduit diameter • firstly blow through the conduit with air, check if penetrable tube/correct tube • make either a loop or fix a bead to the pull line • release line brake • blow pull line in without interrupting, observe uncoiling in cylinder • release switch and close nozzle with a finger • apply line brake and cut off pull line • fix wire/s to the pull line and start pulling Stringing Gun EZ50 Standard equipment in strong plastic case • 1 Stringing Gun EZ50 • 2 pull line rolls ø 1 mm, approx. 900 m, tensile strength approx. 24 kg • 1 suction device • Components set A: 2 joints ½", reduction 19/12 mm and nozzle int. ø 9,5 mm • Components set B: 3 joints ¾", nozzle int. ø 16 mm plus nozzle int. ø 19 mm • 1 special nozzle black, for internal diameter from 25 to 50 mm • 1 special nozzle with 90° angle, external diameter 12 mm (only in connection with special nozzle black) • 3 beads of ø 11, 13 and 16 mm each • Operating instructions

Date posted: 11 May, 2017  |   Location: Sydney -map
Ad Id: 221

Please contact